Planet Solar Power PoE IP30 Industrial Switch

Specifications

Hardware Specifications
Network Connector	3-Port RJ-45 for 10/100/1000Base-T  (2-Port with 802.3at / 802.3af PoE injector function)
Console Port	1 x RS-232 RJ-45 serial port
Power Output	1 x DC out 24@ 2A maximum (two-pin terminal block) 2 x PoE out 52VDC; max. 30 watts per PoE port
LED	System • System (Green) • Fault (Green) Per PoE Port (Port 1 / Port 2) • Link / Active (Green) • PoE In-Use (Orange) LAN Port (Port 3) • 1000 Link / Active (Green) • 10/100 Link / Active (Green) Per PoE Interface • Power LNK/ACT (Green) • PoE In-Use (Orange)
Power over Ethernet
Standard	IEEE802.3at / IEEE802.3af
Port	Port 1, Port 2
Power Pin	RJ-45 Pin# 1/2 (+); Pin# 3/6 (-); PSE End-span
Power Voltage Injecting	DC 52V
Consumption	30 watts max.; PoE Class 4
Electrical Characteristics
System Voltage Ratings	DC 24V
Maximum Charging Current	15A
Max. Solar Array VOC	DC 60V
Max. Operating Voltage	DC 45V
Total Current Consumption	While operating -32Ma At idle -11mA
High Temperature Shutdown	100 degrees C disconnect solar and load 80 degrees C reconnect solar and load
Overload Capacity	Over 15 Amp will cut off output load
Battery Charging Characteristics
Charge Algorithm	Bulk charge (constant current), absorption charge (constant voltage) and floating charge. Absorption and floating charge with PWM protection.
Maximum Output Current	15A
Nickel-cadmium Battery	± 40 mV/degrees Celsius for NiCad type batteries, charge cut-off @ 55 degrees C (Temperature compensation Baseline@ 25 degrees C)
Lead-acid Battery (Default Setting)	± 60 mV/degrees Celsius for lead acid type batteries, charge cut-off @ 55 degrees C (Temperature compensation Baseline@ 25 degrees C)
Float Charge Voltage	DC 27.2V (26.0~30.0V)
Absorption Charge Voltage	DC 29.2V (28.0~32.0V)
LVD (Low Voltage Disconnection)	DC 22.2V (21.0~25.0V)
LVR (Low Voltage Reconnection)	DC 24.8V (23.0~27.0V)