Planet 802.11n 300Mbps In-Wall Access Point w/ USB Charger (EU Type)

Specifications

Hardware Specifications
Interface	PoE Port: 1 x 10/100Mbps Auto MDI/MDI-X RJ45 port (Rear Panel) 　　　 　※ IEEE 802.3af PD Port LAN Port: 1 x 10/100Mbps Auto MDI/MDI-X RJ45 port  RJ-11 Port: Connect to the telephone through the 4-conductor phone line 4-pin Terminal Block: Connect to the PBX through the 4-conductor telephone wire (Rear Panel) USB Port: USB 2.0, Type-A, 5V DC/0.5A Output
PoE Standard	IEEE 802.3af
Antenna	Built-in 3dBi antenna x 2
Reset Button	Reset button an front panel Press over 7 seconds to reset the device to factory default
LED Indicators	PWR/SYS LED
Material	Plastic
Dimensions (W x D x H)	86 x 35 x 86 mm
Weight	103g
Power Requirements	48V DC, 320mA
Power Consumption	< 10W
Wireless interface Specifications
Standard	Compliance with IEEE 802.11b/g/n
Frequency Band	America/ FCC: 2.414~2.462GHz (11 Channels) Europe / ETSI: 2.412~2.472GHz (13 Channels)
Channel Width	20 or 20/40MHz
Transmission Distance	Indoor up to 100m Outdoor up to 300m (it is limited to the environment)
RF Power (Intentional Radiator)	IEEE 802.11b: 18dBm IEEE 802.11g: 15dBm IEEE 802.11n: 15dBm
Wireless Management Features
Wireless Modes	Access Point (Dual-SSID)
Encryption Security	WEP (64/128-bit) WPA-PSK (TKIP) / WPA2-PSK (AES) WPA (TKIP) / WPA2 (AES) 802.1x Authentication
Wireless Security	Enable/Disable SSID Broadcast Wireless LAN ACL (Access Control List) MAC filtering
Wireless Advanced	AP Isolation: Enable it to isolate each connected wireless clients Supports 802.11e WMM (Wi-Fi Multimedia)
Max. Supported Clients	Wire: Not limited Wireless: 25
System Management	Web-based (HTTP) management interface SNMP management, LED On/Off control, Schedule Reboot Supports Planet Smart Discovery & Centralized Management Utility System Log